Requisite Audio Engineering L2M MKIII M/S VERSION Betreibershandbuch

THE PAL PLUS MKIIIMicrophone Preamplifier & Optical Leveling AmplifierBy Requisite Audio EngineeringOPERATOR’S MANUAL2 1 7 5 G o o d y e a r Av

FRONT PANEL CONTROLS (bottom row)HI-Z INPUTThe ¼” jack accepts single-ended outputs ranging from guitar pick-ups to active outputs from keyboards and

FRONT PANEL CONTROLS (bottom row continued)MIC/LINK - OPERATIONAL NOTE: A useful technique is to set one unit to normal compression levels and the sec

FRONT PANEL CONTROLS (bottom row continued)PEAK REDUCTION With PEAK REDUCTION set fully counter-clockwise, the MIC/DI input and LINE input exhibit no

FRONT PANEL CALIBRATION POINTSCALIBRATION POINTS The PAL Plus MkIII has four points of calibration, all of which are found on the front panel. They a

FRONT PANEL CALIBRATION POINTS (continued)VU ADJUST - CALIBRATION PROCEDURE: VU ADJUST is calibrated in dBu. The trimmer has a wide enough range that

FRONT PANEL CALIBRATION POINTS (continued)STEREO ADJUST - CALIBRATION PROCEDURE (continued):•Inject the +10dB 1-kHz tone to the LINE INPUT. Verify lev

FRONT PANEL CALIBRATION POINTS (continued)RESET STEREO ADJUST to higher sensitivity:•Inject a +10dB 1-kHz tone (both channels). Verify level using an

REAR PANEL (LEFT to RIGHT, top and bottom row)GROUNDBanana Plug connection to CHASSIS Ground and/or CIRCUIT Ground is provided. Need for connection is

OUTBOARD POWER SUPPLIESPOWER SUPPLIESFor the PAL Plus MkIII, and all Requisite mainframe audio processors, there is a choice of two different power su

WARRANTYFor a period of 2 years after original purchase, Requisite Audio Engineering will, free of charge, repair this product if it fails due to defe

TABLE OF CONTENTSINTRODUCTION! 1RECEIVING YOUR PAL! 2UNPACKING and INSPECTION:! 2GENERAL NOTES! 3WARNING:! 3THIS SHIPMENT SHOULD INCLUDE:! 3SERVICING:

FRONT PANEL CONTROLS (bottom row)! 6HI-Z INPUT! 6LIMITER RESPONSE! 6LIMITER RESPONSE - OPERATIONAL NOTE:! 6MIC/LINK! 6FRONT PANEL CONTROLS (bottom row

STEREO ADJUST - CALIBRATION PROCEDURE (continued):! 11STEREO ADJUST - OPERATIONAL NOTE:! 11FRONT PANEL CALIBRATION POINTS (continued)! 12RESET STEREO

INTRODUCTIONTHANK YOUThank you for using the PAL Plus MkIII and thereby making it a part of your art. The PAL Plus MkIII is the third generation of o

RECEIVING YOUR PALUNPACKING and INSPECTION:Your shipment has been carefully inspected, checked and packaged at our company be-fore being turned over t

GENERAL NOTESWARNING:DO NOT OPEN THE CABINET - RISK OF SEVERE ELECTRICAL SHOCKTHIS SHIPMENT SHOULD INCLUDE: Model PAL Plus MkIII Model OPS-2D Solid-St

FRONT PANEL CONTROLS (top row)MIC/DI - LINEThis switch selects between the transformer balanced microphone input and the transformer balanced +4 line

FRONT PANEL CONTROLS (top row continued)-20dB PAD Applied only to the mic input before the microphone input transformer. If your source volume is ext